The bug appeared. You weren’t recording.
Some failures appear after hours. Standard capture tools show you when the failure occurs. Exostiv shows you everything that happened before it.
The scenario you recognize
You set a trigger. The design runs. The failure happens — somewhere outside the capture window, or the buffer fills before the context you need is visible.
You restart. You adjust the trigger. You try again. Each cycle costs hours, and the bug may not repeat the same way twice.
This is not a workflow problem. It is a physics problem: when capture memory is in the FPGA, you get kilobytes. When it is on the debug instrument, you get hours.
Why the window is always too short
On-chip debug tools store captures in BRAM shared with your design. That is a hardware architecture constraint, not a software limitation — no firmware update or tool upgrade changes it. The capture window is bounded by what is left on the chip after your design is placed.
For sporadic bugs, timing-sensitive interactions, and behaviors that only emerge after minutes of real operation, this is not enough. The failure is real. The record of it is gone.
What Exostiv does differently
Exostiv routes captured signal data through FPGA transceivers to external memory on the probe unit. The design keeps running at full speed. You decide when to stop the capture — not the buffer.
This means you can instrument your prototype before you know what you are looking for. When the failure surfaces, you already have the full record of everything that happened before it.
Aggregated captures that span over seconds, minutes, or hours. The bug does not have to repeat.

The numbers
The numbers
8 GB of capture memory per Probe unit.
Up to terabytes across Blade configurations.
One software environment from single-board bench setup to multi-FPGA lab.
No restarts. No trigger roulette. No lost context.
See it on your board – Request a demo.